Sargent PASSPORT 1000 Exit Device Installation Instructions Manual page 21

Passport 1000 P1 Exit Device
Installation Instructions for Mortise Type 8977/8978 Exit Device
8
1 Door Preparation
A. Verify Hand and Bevel of Door
• Check hand of door.
This exit device is handed and is not reversible.
• Door should be fitted and hung.
B. Verify Product Label
C. Door Preparation
1. If using a mullion, install it prior to installing hardware.
2. Doors should be pre-prepped (recommended).
3. Use appropriate templates:
• Passport 1000 template A8074 (with DPS); A8075 (without DPS)
• Exit installation instructions A6705.
Note: Instruction examples show wood door installation.
For metal doors, route cables inside door.
Outside of Door
Through Bolt Hole
Wire Cutout
Cylinder Hole
Lever Hole
Left Hand
Reverse
LHR
Door
Position
Switch
ET Through
Bolt Hole
Mortise
Pocket
ET Through
Bolt Hole
Fig. 1B
21 1-800-810-WIRE • www.sargentlock.com • A8034G
Inside
Right Hand
Reverse
RHR
Outside
Fig. 1A
Inside of Door
Through Bolt Hole
Wire Run Channel (Wood Door)