Sargent PASSPORT 1000 Exit Device Installation Instructions Manual page 14

4 Mount Exit Device Chassis
1. Position exit chassis carefully, verifying that the ET
spindle engages the lower hub of the exit chassis.
DO NOT PINCH THE WIRE HARNESS.
2. Secure the exit chassis with through bolts
to the ET trim using (2) 1/4 -20 x 2-3/8"
flat head machine screws.
3. For wood door applications, attach
ground harness (Fig. 4C) using the
top through-bolt screw.
Fig. 4A
5 Install Cylinder
For devices without cylinder, go to Step 6.
1. While installing the rim cylinder, support the tail piece of the cylinder,
verifying its engagement with the top hub of the exit chassis
Note: Be sure ET harness is clear of cylinder and tailpiece.
2. Secure the cylinder by through-bolting the cylinder
through the exit chassis using (2) #12-24 x 1-7/8"
connecting screws (see Fig. 6A).
3. Verify that the key retracts latchbolt.
Position cylinder so that the SAR-
1-800-810-WIRE • www.sargentlock.com • A8034G
ET Wire Harness
Inside of Door (Metal)
Exit Chassis
GENT logo is right-side up.
Correct Incorrect
Fig. 5B
Passport 1000 P1 Exit Device
Inside of Door (Wood)
ET Wire Harness
Exit Chassis
(2) 1/4 x 2-3/8"
Flathead Machine
Screws (secures ET)
Fig. 5A
14
Ground Harness (from
motor, wood doors only)
Put ground lug through
top flat head screw and
tighten down.
(2) 1/4 x 2-3/8"
Flathead Machine
Screws (secures ET)
Fig. 4B