The following screen is displayed:
Figure D.4 Imaging Tab
This window lists all the presets, both predefined and custom. Presets are identified
as follows:
•
Predefined presets are marked as read-only.
Custom presets are marked as read and write.
•
•
One preset – either predefined or custom – is marked as active.
D.3.2
Selecting A Camera
If your EP10 has more than one built-in camera, one camera must be selected for configura-
tion. To select a camera:
Tap on the Camera Presets dropdown menu to view the camera options.
•
•
Choose a camera – either Front Imager, the imager located at the top of the unit, or
Bottom Colour Camera, the camera located at back of the EP10.
Important: Currently, only the 'Front Imager' can be used to read bar codes. The
D.3.3
Setting The Active Preset
An active preset has an A to the right; in Figure D.4 on page D-5, the active preset is Low
light near. To set an active preset:
•
Highlight the preset, and tap on the Activate button.
Preliminary Draft
'Bottom Colour Camera' is limited to taking photos.
EP10 Hand-Held (Windows Embedded 6.5) User Manual
Appendix D: Teklogix Imagers Applet
Selecting A Camera
D-5