Tap on the proxy type you want to change. For the appropriate server type, type the
•
proxy server name and port.
•
Tap on OK.
5.43
Wireless Statistics
•
Tap on Start>Settings>Connections tab>Wireless Statistics icon to display the com-
munication statistics of your wireless connection along with the radio card name, MAC
address, driver version and NDIS Compliance information.
•
Tap on the Zero button to reset the statistics.
5.44
Wireless WAN
An EP10 equipped with a UMTS radio has wide area networking data transfer capabilities.
5.44.1 Softkey Bar Icons
Wireless WAN icons in the softkey bar indicate the status of your wide area network con-
nection. Note that these icons are only visible when a GSM/GPRS, CDMA/1xRTT or
UMTS radio is installed in the unit, and the interface is enabled.
The letter in the signal strength icon (G for GSM/GPRS, U for UMTS and X for
CDMA/1xRTT) indicates that a packet data service is available and initialized. Keep in
mind that the signal strength icon is displayed without a letter if packet data service is not
available or if it is available but not yet initialized.
User interaction is required (e.g. the user is required to enter a PIN).
A non-recoverable (fatal) error has occurred.
GSM/GPRS Status Indicators
Signal strength is between 1% and 20%.
Signal strength is between 21% and 40%.
Signal strength is between 41% and 60%.
Signal strength is between 61% and 80%.
Signal strength is between 81% and 100%.
Preliminary Draft
EP10 Hand-Held (Windows Embedded 6.5) User Manual
Chapter 5: Settings
Wireless Statistics
197