Snap Modules - Psion 7515 User Manual

Chapter 6: Peripheral Devices & Accessories

Snap Modules

• Reconnect the mains power cable, and check that the slot indicator flashes at powerup.
6.8

Snap Modules

The Snap Module is a mobile power adaptor that snaps on the base of the EP10. Two types
of Snap Modules are available:
• USB and Charge Snap Module – Model No. RV4001. This accessory powers and
charges the EP10, and it provides a USB connection.
• DE9 RS232 and Charge Snap Module – Model No. RV4002. This accessory powers
and charges the EP10 and provides a RS232 connection.
The Snap Modules are compatible with the AC Wall Adaptor and the Vehicle Power Outlet
Adaptor.
To attach an adaptor to the EP10:
• Make sure that the adaptor connector and EP10 docking connector are free of dust or
any other debris before connecting them.
• A slot in the side rail on each side of the hand-held accommodates the locking clips of
the adaptor. To attach the adaptor, align it with the base of the hand-held and gently slide
up until the locking clips snap into place. Refer to TBD illustration.
• To remove the adaptor, press down on the base of the clip arms to release them from the
EP10 side rails and slide the adaptor off.
236 EP10 Hand-Held (Windows Embedded 6.5) User Manual
Preliminary Draft
PLACE HOLDER
Snap Module installation illustration