Operator Controls; Charge Indicators - Psion 7515 User Manual

Chapter 6: Peripheral Devices & Accessories

Operator Controls

maximum performance, it is recommended that the charger be operated at room temperature
– a temperature range between 18°C to 25°C (64°F to 77°F).
The charger can consume up to 6 A at 120 VAC, 3A at 240 VAC. Check to ensure the mains
circuit supplying the charger is adequate for this loading (especially if several chargers are
being powered from the same circuit). After unpacking the unit:
• Visually check the charger for damage.
• Install the IEC power cord and apply power.
Important: Use IEC-320 C13 power cords approved by Psion Teklogix, with the ground
All charge indicators flash momentarily at powerup to indicate that the charger is ready for
operation.
If you choose to wall mount the charger, detailed installation instructions are included in the
EP10 Quad Charger Quick Start Guide (PN TBD) included with the charger kit. Be sure to
locate the charger in an area where there is no risk of injury to persons walking in the
vicinity.
6.7.3

Operator Controls

The gang charger does not have operator controls or a power switch. There is no dedicated
indicator light to show that the charger is powered, but the charge slot LEDs will light.
6.7.4

Charge Indicators

Each battery charge slot is equipped with four LEDs to indicate the charge status of the bat-
tery. When the EP10 batteries are inserted in the charger, the colour and behaviour of the
LEDs associated with the charge wells in use indicate the status of the charge.
Table 6.1 Charge Status Indicator LEDs
Charge LED Behaviour
OFF
Solid Green
Flashing Green
234 EP10 Hand-Held (Windows Embedded 6.5) User Manual
Preliminary Draft
pin connected to a proper earth-grounded receptacle. Check with a quali-
fied electrician if you are uncertain of your receptacle grounding.
No battery detected.
Battery charging complete. Each LED represents 25% battery capacity.
Charge in progress. Each LED represents 25% battery capacity.
Function