Psion 7515 User Manual page 234

Chapter 6: Peripheral Devices & Accessories
The Hand Strap with Tether – Model No. RV6021
Figure 6.1 Attaching The Hand Strap
1. Attach the hand strap to the EP10 by looping the Velcro tab around the pin and adhering
the tab to the Velcro pad (TBD).
2. Remove the bracket and screws from the EP10.
3. Slide the bracket through the plastic loop on the hand strap and install the screws.
4. Adjust the hand strap by pulling up the Velcro tab and readjusting to your hand
as needed.
Attaching the Stylus and Tether
The stylus tether can be attached to the hand strap at the back of the EP10.(TBD)
1. If not assembled, thread the tether cord through the stylus as shown, pulling the
cord tight.
2. Thread the tether through the eyelet on the strap.
3. Pass the stylus through the tether loop and pull the tether snug.
4. Slip the stylus into the elastic holder, and you're finished.
220 EP10 Hand-Held (Windows Embedded 6.5) User Manual
Preliminary Draft
Back of EP10
Hand Strap Bar
Hand Strap
Anchor