Table of Contents
Advertisement
C.4
Imager
Tap on the Scanner drop down menu, and choose Imager.
•
C.4.1
Options – Imager
Center Barcode Only
Note: This parameter must be disabled when reading Composite bar codes.
When more than one bar code is visible in a single snap shot, this parameter allows you to
specify that only the centre image within the imager framing marker be read. When
this parameter is set to on, the target dot is pointed at the centre image and only that image
is returned.
Max Number Barcodes
This parameter specifies the maximum number of bar codes the imager will attempt to
decode in an image. A maximum of 6 bar codes can be decoded at one time.
Barcodes Must Decode
This parameter specifies the minimum number of bar codes that the imager must decode in
order to report success.
Note: This number must be less than the number of bar codes assigned to "Max Number
Barcodes". The driver validates and reassigns the value if necessary.
Preliminary Draft
EP10 Hand-Held (Windows Embedded 6.5) User Manual
Appendix C: Bar Codes Settings
Imager
C-37
Advertisement
Table of Contents
Troubleshooting
