Quad Dock Operation; Charging The Ep10 Battery; Connecting To The Ethernet Network - Psion 7515 User Manual

6.6.3

Quad Dock Operation

6.6.3.1 Charging the EP10 Battery

• Insert the DC power MINI FIT JR plug into the RV4004 rear DC input receptacle. The
adaptor LED should be ON when powered from the mains.
The RV4004 supplies DC power to enable the EP10 internal fast charger. Normally, a full
charge of the 3600 mAh EP10 battery will take from 2.5 to 3.0 hours.
• Insert up to four EP10s into the docking station charge wells, pressing down gently but
firmly to seat them securely.
• During the charge, the EP10 LED slow flashes green.
• When the battery capacity reaches 95%, the LED turns solid green.
Note: Battery charging continues whether the EP10 is switched on or off.

6.6.3.2 Connecting to the Ethernet Network

The rear-mounted RJ45 connector incorporates LEDs that indicate data traffic (see
Figure 6.7) when:
• The EP10 is in the docking station and powered on;
• The docking station is powered by the AC adaptor;
• The docking station is connected to Ethernet network with a Category 5 cable plugged
into the RJ45 rear socket.
The green Link LED flashes to indicate the presence of data traffic. The yellow Speed LED
is steady ON when the network is 100 Mbps and OFF when the network is 10 Mbps.
Preliminary Draft
EP10 Hand-Held (Windows Embedded 6.5) User Manual
Chapter 6: Peripheral Devices & Accessories

Quad Dock Operation

231