Vehicle Cradle Mounting Recommendations; Removing The Ep10 From The Vehicle Cradle; Mounting Template - Psion 7515 User Manual

Chapter 6: Peripheral Devices & Accessories

Vehicle Cradle Mounting Recommendations

6.11.2.4 Removing the EP10 from the Vehicle Cradle

When removing the EP10, apply slight pressure to the rear and pull upwards. The rear-first
motion will assist in disengaging the rear restraining mechanism.

6.11.3 Vehicle Cradle Mounting Recommendations

Warning: Before mounting a vehicle cradle in a vehicle, there are a number of opera-
Pedestal mounts are recommended for all fixed mount locations because they offer optimal
operator access. In addition, for safety reasons, only pedestal mounts with fully locking
joints should be used in vehicles. Always adjust the pedestal for the optimum viewing angle,
and securely tighten the hex and wing screws.
Important: EP10 vehicle cradles are designed to be compatible with any RAM
The most effective way to mount the vehicle cradle RAM mount is to use the seven #M4
threaded inserts on the rear of the unit. Bolts must not extend more than 5mm into the
vehicle cradle. You may also remove the rear Ram-B mount accessory to custom mount the
vehicle cradle to a surface other than the recommended RAM-B (Figure 6.11 on page 241).

6.11.3.1 Mounting Template

The vehicle cradle is shipped with detailed mounting instructions including a drill template.
Refer to the RV1000 EP10 Hand-Held Vehicle Cradle Quick Start Guide (PN 8000234).
In every case, please take the following precautions:
1. When installing the cradle, ensure the driver's view is not obstructed.
240 EP10 Hand-Held (Windows Embedded 6.5) User Manual
Preliminary Draft
tor safety issues that require careful attention. An improperly mounted
cradle may result in one or more of the following: operator injury, operator
visibility obstruction, operator distraction and/or poor ease of egress for the
operator. Psion Teklogix strongly recommends that you seek professional
mounting advice from the vehicle manufacturer.
Cable routing within a vehicle cab also requires careful consideration, espe-
cially for separately tethered scanners and other devices with loose cables. If
you are unable to obtain suitable advice, contact Psion Teklogix for assist-
ance (see Appendix A: "Summit Client Utility (SCU)". Note also that for
better protection, the equipment should be mounted inside the vehicle roll
cage.
mounting interface. For other mounting options please contact our Techni-
cal Support offices.
®
-B