Wiring Vehicle Power To The Cradle - Psion 7515 User Manual

Chapter 6: Peripheral Devices & Accessories
Electrical Requirements
Warning: Applying a voltage above 36VDC or reversing polarity may result in perma-

6.12.3.1 Wiring Vehicle Power to the Cradle

The Powered Vehicle Cradle uses the vehicle power outlet or the vehicle fuse box to power
from the vehicle battery system. The Vehicle Outlet Power Adaptor (Model No. RV3050) is
used for the vehicle power outlet; the Power Extension cable (PN 1081146) is used for the
vehicle fuse box.
Figure 6.14 Vehicle Outlet Power Adaptor and Power Extension Cable
Warning: A properly trained technician must perform the power connection using
Power cables are equipped with fuses and instructions are supplied with each cable. Use
only a 4A slow blow Safety-approved fuse in the fuse assembly.
These cables should only supply operating power from the vehicle to the Powered Vehicle
Cradle from 12VDC or 24VDC systems.
246 EP10 Hand-Held (Windows Embedded 6.5) User Manual
Preliminary Draft
nent damage to the vehicle cradle power section and will void the product
warranty. For safety reasons, disconnect the vehicle cradle power cable
when the vehicle battery is being charged by an source other than the
vehicle alternator.
Power Extension cable (PN 1081146) and the RV1005. Improper connection
can damage the vehicle or the cradle.
This cable can be used to provide power to RV1005 from a fused circuit. The
vehicle cradle should be added to a fused circuit with a new maximum load
capacity of the original load plus the cradle load, which is 4A.