Charging A Spare Battery; Operating The Usb Dock - Psion 7515 User Manual

LED. Refer to "Charging a Spare Battery" in the next section for details about
LED behaviour.
Note: Battery charging continues whether the EP10 is switched on or off.

6.5.3.2 Charging a Spare Battery

Note: Do not store a spare battery in a charger for more than 72 hours. Doing so may
damage the battery or reduce its charge capacity.
• Insert the spare battery in the charge well at the back of the RV4000, aligning the con-
tacts on the battery with the contacts in the spare battery charge well.
A full charge takes 2.5 to 3.0 hours for the 3600 mAh battery.
When the battery capacity reaches 95%, the LED turns solid green and remains in this state
once the battery is completely charged.

6.5.3.3 Operating the USB Dock

The RV4000 Desktop Docking Station offers a rear-mounted host or device USB connection
to the EP10. The EP10 supports communication with low- and full-speed USB 1.1 compli-
ant devices and hosts through the docking station. The Type B receptacle may be used for
ActiveSync® among other applications typical for a Type B device (Figure 6.5 on
page 228).
• Move the sliding door to the left or right to alternate between the Type A and Type B
USB ports.
Preliminary Draft
EP10 Hand-Held (Windows Embedded 6.5) User Manual
Chapter 6: Peripheral Devices & Accessories
Operation
227