Powering On And Off; Console Management Power (Cpower) Commands; Table 1-1 Cpower Option, Action, Target Type And Target List Descriptions - Silicon Graphics ICE X User Manual

1: Operation Procedures

Powering On and Off

Console Management Power (cpower) Commands

8
The power-on and off procedure varies with your system setup. See the SGI Management Center
Administration Guide for Clusters, (P/N 007-6358-00x) for a more complete description of system
commands. The listed commands are supported with SMC 3.1 or later management software.
Note: The cpower commands are normally run through the administration node. If you have a
terminal connected to an administrative server with a serial interface, you should be able execute
these commands.
This section provides an overview of the console management power (cpower) commands for
the SGI ICE X system.
The cpower commands allow you to power on, power off, reset, and show the power status of
multiple or single system components or individual racks.
The cpower command is, as follows:
cpower <option...> <target_type> <action> <target_list>
Example cpower command arguments are listed and described in Table 1-1. See Table 1-2 on
page 11 for examples of the cpower command strings.
Table 1-1
cpower option, action, target type and target list descriptions
Argument
Option
-h | --help
-w | --wait
-i seconds |
--interval=seconds
-u | --no-umatched
-v | --verbose
Description
Show this help message and then exit.
Wait for certain operations, (verification waiting timeout).
Specifies how long a target component's LED will stay lit. This is valid with
the "identify" action (see the action descriptions). Specify a number of
seconds or use 0 to turn off the LED immediately. Also valid with reboot,
reset and on actions.
Unmatched target messages will be suppressed in the command output.
Report command progress details and all errors.
007-5806-004