Ip Igmp Snooping Vlan Immediate-Leave - Edge-Core ES3510MA-DC Management Manual

| Multicast Filtering Commands
C 38
HAPTER
IGMP Snooping
ip igmp snooping
vlan immediate-
leave
This command immediately deletes a member port of a multicast service if
a leave packet is received at that port and immediate-leave is enabled for
the parent VLAN. Use the no form to restore the default.
S
YNTAX
[no] ip igmp snooping vlan vlan-id immediate-leave
vlan-id - VLAN ID (Range: 1-4093)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
If immediate-leave is not used, a multicast router (or querier) will send
◆
a group-specific query message when an IGMPv2/v3 group leave
message is received. The router/querier stops forwarding traffic for that
group only if no host replies to the query within the time out period.
(The time out for this release is currently defined by Last Member
Query Interval (fixed at one second) * Robustness Variable (fixed at 2)
as defined in RFC 2236.
If immediate-leave is enabled, the switch assumes that only one host is
◆
connected to the interface. Therefore, immediate leave should only be
enabled on an interface if it is connected to only one IGMP-enabled
device, either a service host or a neighbor running IGMP snooping.
This command is only effective if IGMP snooping is enabled, and
◆
IGMPv2 or IGMPv3 snooping is used.
E
XAMPLE
The following shows how to enable immediate leave.
Console(config)#ip igmp snooping vlan 1 immediate-leave
Console(config)#
– 906 –