Configuring Vlan Settings For Arp Inspection - Edge-Core ES3510MA-DC Management Manual

◆
◆
W
To configure global settings for ARP Inspection:
1.
2.
3.
4.
Figure 183: Configuring Global Settings for ARP Inspection
Use the Security > ARP Inspection (Configure VLAN) page to enable ARP
C VLAN
ONFIGURING
inspection for any VLAN and to specify the ARP ACL to use.
S ARP
ETTINGS FOR
I
NSPECTION
CLI R
◆
C
ARP Inspection VLAN Filters (ACLs)
◆
◆
Src-MAC – Validates the source MAC address in the Ethernet
■
header against the sender MAC address in the ARP body. This check
is performed on both ARP requests and responses.
Log Message Number – The maximum number of entries saved in a
log message. (Range: 0-256; Default: 5)
Log Interval – The interval at which log messages are sent.
(Range: 0-86400 seconds; Default: 1 second)
I
EB NTERFACE
Click Security, ARP Inspection.
Select Configure General from the Step list.
Enable ARP inspection globally, enable any of the address validation
options, and adjust any of the logging parameters if required.
Click Apply.
EFERENCES
"ARP Inspection" on page 687
U
OMMAND SAGE
By default, no ARP Inspection ACLs are configured and the feature is
disabled.
ARP Inspection ACLs are configured within the ARP ACL configuration
page (see page 323).
– 329 –
| Security Measures
C 14
HAPTER
ARP Inspection