Edge-Core ES3510MA-DC Management Manual page 342

| Security Measures
C 14
HAPTER
Configuring 802.1X Port Authentication
P
ARAMETERS
These parameters are displayed:
Port – Port number.
◆
Status – Indicates if authentication is enabled or disabled on the port.
◆
The status is disabled if the control mode is set to Force-Authorized.
Authorized – Displays the 802.1X authorization status of connected
◆
clients.
Yes – Connected client is authorized.
■
No – Connected client is not authorized.
■
Supplicant – Indicates the MAC address of a connected client.
◆
◆ Control Mode – Sets the authentication mode to one of the following
options:
Auto – Requires a dot1x-aware client to be authorized by the
■
authentication server. Clients that are not dot1x-aware will be
denied access.
Force-Authorized – Forces the port to grant access to all clients,
■
either dot1x-aware or otherwise. (This is the default setting.)
Force-Unauthorized – Forces the port to deny access to all
■
clients, either dot1x-aware or otherwise.
Operation Mode – Allows single or multiple hosts (clients) to connect
◆
to an 802.1X-authorized port. (Default: Single-Host)
Single-Host – Allows only a single host to connect to this port.
■
Multi-Host – Allows multiple host to connect to this port.
■
In this mode, only one host connected to a port needs to pass
authentication for all other hosts to be granted network access.
Similarly, a port can become unauthorized for all hosts if one
attached host fails re-authentication or sends an EAPOL logoff
message.
MAC-Based – Allows multiple hosts to connect to this port, with
■
each host needing to be authenticated.
In this mode, each host connected to a port needs to pass
authentication. The number of hosts allowed access to a port
operating in this mode is limited only by the available space in the
secure address table (i.e., up to 1024 addresses).
Max MAC Count – The maximum number of hosts that can connect to
◆
a port when the Multi-Host operation mode is selected.
(Range: 1-1024; Default: 5)
– 342 –