Vlan-Trunking - Edge-Core ES3510MA-DC Management Manual

| VLAN Commands
C 35
HAPTER
Configuring VLAN Interfaces

vlan-trunking

This command allows unknown VLAN groups to pass through the specified
interface. Use the no form to disable this feature.
S
YNTAX
[no] vlan-trunking
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
Use this command to configure a tunnel across one or more
◆
intermediate switches which pass traffic for VLAN groups to which they
do not belong.
The following figure shows VLANs 1 and 2 configured on switches A and
B, with VLAN trunking being used to pass traffic for these VLAN groups
across switches C, D and E.
Figure 304: Configuring VLAN Trunking
Without VLAN trunking, you would have to configure VLANs 1 and 2 on
all intermediate switches – C, D and E; otherwise these switches would
drop any frames with unknown VLAN group tags. However, by enabling
VLAN trunking on the intermediate switch ports along the path
connecting VLANs 1 and 2, you only need to create these VLAN groups
in switches A and B. Switches C, D and E automatically allow frames
with VLAN group tags 1 and 2 (groups that are unknown to those
switches) to pass through their VLAN trunking ports.
◆ VLAN trunking is mutually exclusive with the "access" switchport mode
(see the switchport mode
interface, then that interface cannot be set to access mode, and vice
versa.
To prevent loops from forming in the spanning tree, all unknown VLANs
◆
will be bound to a single instance (either STP/RSTP or an MSTP
instance, depending on the selected STA mode).
If both VLAN trunking and ingress filtering are disabled on an interface,
◆
packets with unknown VLAN tags will still be allowed to enter this
interface and will be flooded to all other ports where VLAN trunking is
– 838 –
command). If VLAN trunking is enabled on an