Wtr-Timer; Show Erps - Edge-Core ES3510MA-DC Management Manual

| ERPS Commands
C 34
HAPTER

wtr-timer

show erps

The east and west connections to the ring must be specified for all ring
◆
nodes using the ring-port
the RPL owner, the west ring port is set as being connected to the RPL.
E
XAMPLE
Console(config-erps)#rpl owner
Console(config-erps)#
This command sets the wait-to-restore timer which is used to verify that
the ring has stabilized before blocking the RPL after recovery from a signal
failure. Use the no form to restore the default setting.
S
YNTAX
wtr-timer minutes
minutes - The wait-to-restore timer is used to verify that the ring
has stabilized before blocking the RPL after recovery from a signal
failure. (Range: 5-12 minutes)
D S
EFAULT ETTING
5 minutes
C M
OMMAND ODE
ERPS Configuration
C U
OMMAND SAGE
If the switch goes into ring protection state due to a signal failure, after the
failure condition is cleared, the RPL owner will start the wait-to-restore
timer and wait until it expires to verify that the ring has stabilized before
blocking the RPL and returning to the Idle (normal operating) state.
E
XAMPLE
Console(config-erps)#wtr-timer 10
Console(config-erps)#
This command displays status information for all configured rings, or for a
specified ring
S
YNTAX
show erps [domain ring-name]
ring-name - Name of a specific ERPS ring. (Range: 1-32 characters)
C M
OMMAND ODE
Privileged Exec
– 822 –
command. When this switch is configured as