| LLDP Commands
C
39
HAPTER
lldp med-tlv
network-policy
lldp notification
This command configures an LLDP-MED-enabled port to advertise its
network policy configuration. Use the no form to disable this feature.
S
YNTAX
[no] lldp med-tlv network-policy
D
S
EFAULT
ETTING
Enabled
C
M
OMMAND
ODE
Interface Configuration (Ethernet, Port Channel)
C
U
OMMAND
SAGE
This option advertises network policy configuration information, aiding in
the discovery and diagnosis of VLAN configuration mismatches on a port.
Improper network policy configurations frequently result in voice quality
degradation or complete service disruption.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp med-tlv network-policy
Console(config-if)#
This command enables the transmission of SNMP trap notifications about
LLDP changes. Use the no form to disable LLDP notifications.
S
YNTAX
[no] lldp notification
D
S
EFAULT
ETTING
Enabled
C
M
OMMAND
ODE
Interface Configuration (Ethernet, Port Channel)
C
U
OMMAND
SAGE
This option sends out SNMP trap notifications to designated target
◆
stations at the interval specified by the
command. Trap notifications include information about state changes in
the LLDP MIB (IEEE 802.1AB), or organization-specific LLDP-EXT-DOT1
and LLDP-EXT-DOT3 MIBs.
◆
SNMP trap destinations are defined using the
command.
Information about additional changes in LLDP neighbors that occur
◆
between SNMP notifications is not transmitted. Only state changes that
exist at the time of a trap notification are included in the transmission.
– 950 –
lldp notification-interval
snmp-server host