Edge-Core ES3510MA-DC Management Manual page 576

| SNMP Commands
C 22
HAPTER
To send an inform to a SNMPv2c host, complete these steps:
Enable the SNMP agent
1.
Create a view with the required notification messages
2.
Create a group that includes the required notify view
3.
Allow the switch to send SNMP traps; i.e., notifications
4.
Specify the target host that will receive inform messages with the
5.
snmp-server host command as described in this section.
To send an inform to a SNMPv3 host, complete these steps:
Enable the SNMP agent
1.
Create a local SNMPv3 user to use in the message exchange
2.
process (page 579).
Create a view with the required notification messages
3.
Create a group that includes the required notify view
4.
Allow the switch to send SNMP traps; i.e., notifications
5.
Specify the target host that will receive inform messages with the
6.
snmp-server host command as described in this section.
The switch can send SNMP Version 1, 2c or 3 notifications to a host IP
◆
address, depending on the SNMP version that the management station
supports. If the snmp-server host command does not specify the
SNMP version, the default is to send SNMP version 1 notifications.
If you specify an SNMP Version 3 host, then the community string is
◆
interpreted as an SNMP user name. The user name must first be
defined with the snmp-server user
group will be automatically created by the snmp-server host
command using the name of the specified community string, and
default settings for the read, write, and notify view.
E
XAMPLE
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
R C
ELATED OMMANDS
snmp-server enable traps (573)
– 576 –
(page 570).
(page 570).
command. Otherwise, an SNMPv3
(page 580).
(page 578).
(page 573).
(page 580).
(page 578).
(page 573).