Edge-Core ES3510MA-DC Management Manual page 71

To obtain IP settings via DHCP, type "ip address dhcp" and press
■
<Enter>.
To obtain IP settings via BOOTP, type "ip address bootp" and press
■
<Enter>.
Type "end" to return to the Privileged Exec mode. Press <Enter>.
3.
Wait a few minutes, and then check the IP configuration settings by
4.
typing the "show ip interface" command. Press <Enter>.
Then save your configuration changes by typing "copy running-config
5.
startup-config." Enter the startup file name and press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ip address dhcp
Console(config-if)#end
Console#show ip interface
Loopback 0 is Administrative Up - Link Up
Address is 00-00-00-00-00-00
Index: 746, MTU: 0
Address Mode is User specified
VLAN 1 is Administrative Up - Link Up
Address is 00-12-CF-DA-FC-E8
Index: 1001, MTU: 1500
Address Mode is DHCP
IP Address: 192.168.0.2 Mask: 255.255.255.0
Console#copy running-config startup-config
Startup configuration file name []: startup
\Write to FLASH Programming.
\Write to FLASH finish.
Success.
O IP 6 A
BTAINING AN V DDRESS
Link Local Address — There are several ways to configure IPv6 addresses.
The simplest method is to automatically generate a "link local" address
(identified by an address prefix of FE80). This address type makes the
switch accessible over IPv6 for all devices attached to the same local
subnet.
To generate an IPv6 link local address for the switch, complete the
following steps:
From the Global Configuration mode prompt, type "interface vlan 1" to
1.
access the interface-configuration mode. Press <Enter>.
Type "ipv6 enable" and press <Enter>.
2.
Console(config)#interface vlan 1
Console(config-if)#ipv6 enable
Console(config-if)#end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled.
Link-local address:
– 71 –
| Initial Switch Configuration
C 2
HAPTER
Basic Configuration