Configuring Port-Based Traffic Segmentation; Traffic-Segmentation; Table 115: Commands For Configuring Traffic Segmentation - Edge-Core ES3510MA-DC Management Manual

| VLAN Commands
C 35
HAPTER

Configuring Port-based Traffic Segmentation

C P
ONFIGURING ORT

traffic-segmentation

Console(config-if)#end
Console#show dot1q-tunnel
Current double-tagged status of the system is Enabled
The dot1q-tunnel mode of the set interface 1/1 is Access mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/2 is Uplink mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/3 is Normal mode, TPID is 0x8100.
. .
.
Console#show dot1q-tunnel interface ethernet 1/5
802.1Q Tunnel Service Subscriptions
Port Match C-VID S-VID Remove C-Tag
-------- ----------- ----- ------------
Eth 1/ 5 1
Console#show dot1q-tunnel service 100
802.1Q Tunnel Service Subscriptions
Port Match C-VID S-VID Remove C-Tag
-------- ----------- ----- ------------
Eth 1/ 5 1
Eth 1/ 6 1
Console#
R C
ELATED OMMANDS
switchport dot1q-tunnel mode
- T S
BASED RAFFIC EGMENTATION
If tighter security is required for passing traffic from different clients
through downlink ports on the local network and over uplink ports to the
service provider, port-based traffic segmentation can be used to isolate
traffic for individual clients.

Table 115: Commands for Configuring Traffic Segmentation

Command
traffic-segmentation
show traffic-
segmentation
This command enables traffic segmentation globally, or configures the
uplink and down-link ports for a segmented group of ports. Use the no
form to disable traffic segmentation globally.
S
YNTAX
[no] traffic-segmentation [uplink interface-list
downlink interface-list]
uplink – Specifies an uplink interface.
downlink – Specifies a downlink interface.
– 846 –
100 Disabled
100 Disabled
100 Enabled
(842)
Function
Enables and configures traffic segmentation
Displays the configured traffic segments
Mode
GC
PE