Edge-Core ES3510MA-DC Management Manual page 70

| Initial Switch Configuration
C 2
HAPTER
Basic Configuration
Console(config)#interface vlan 1
Console(config-if)#ipv6 address 2001:DB8:2222:7272::/64
Console(config-if)#exit
Console(config)#ipv6 default-gateway 2001:DB8:2222:7272::254
Console(config)end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled.
Link-local address:
FE80::260:3EFF:FE11:6700/64
Global unicast address(es):
2001:DB8:2222:7272::/64, subnet is 2001:DB8:2222:7272::/64
Joined group address(es):
FF02::1:FF00:0
FF02::1:FF11:6700
FF02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
Console#show ipv6 default-gateway
ipv6 default gateway:
Console#
D C
YNAMIC ONFIGURATION
Obtaining an IPv4 Address
If you select the "bootp" or "dhcp" option, the system will immediately
start broadcasting service requests. IP will be enabled but will not function
until a BOOTP or DHCP reply has been received. Requests are broadcast
every few minutes using exponential backoff until IP configuration
information is obtained from a BOOTP or DHCP server. BOOTP and DHCP
values can include the IP address, subnet mask, and default gateway. If
the DHCP/BOOTP server is slow to respond, you may need to use the "ip
dhcp restart client" command to re-start broadcasting service requests.
Note that the "ip dhcp restart client" command can also be used to start
broadcasting service requests for all VLANs configured to obtain address
assignments through BOOTP or DHCP. It may be necessary to use this
command when DHCP is configured on a VLAN, and the member ports
which were previously shut down are now enabled.
If the "bootp" or "dhcp" option is saved to the startup-config file (step 6),
then the switch will start broadcasting service requests as soon as it is
powered on.
To automatically configure the switch by communicating with BOOTP or
DHCP address allocation servers on the network, complete the following
steps:
From the Global Configuration mode prompt, type "interface vlan 1" to
1.
access the interface-configuration mode. Press <Enter>.
At the interface-configuration mode prompt, use one of the following
2.
commands:
– 70 –
2001:DB8:2222:7272::254