Configuring Load Sharing For Link Aggregation Groups; Configuring Load-Sharing Criteria For Link Aggregation Groups - HP 5120 EI Series Lan Switching Configuration Manual

Step
2. Enter aggregate interface view.
3. Restore the default settings for the
aggregate interface.
Configuring load sharing for link aggregation
groups

Configuring load-sharing criteria for link aggregation groups

You can determine how traffic is load-shared in a link aggregation group by configuring load-sharing
criteria. The criteria can be source/destination MAC addresses, source/destination service port numbers,
ingress ports, source/destination IP addresses, or any combination.
You can configure global or group-specific load-sharing criteria. A link aggregation group preferentially
uses the group-specific load-sharing criteria. If no group-specific load-sharing criteria are available, the
group uses the global load-sharing criteria.
NOTE:
The load sharing criteria configuration applies to only unicast packets, and can change the load sharing
criteria for unicast packets. Broadcast packets and multicast packets always use the default load sharing
criteria.
Configuring the global link-aggregation load-sharing criteria
Step
1. Enter system
view.
2. Configure the
global
link-aggregation
load-sharing
criteria.
In system view, the switch supports the following load-sharing criteria and combinations:
Load-sharing criteria automatically determined based on the packet type
•
Source IP address
•
• Destination IP address
Command
•
default
Command
system-view
link-aggregation load-sharing
mode { destination-ip |
destination-mac | destination-port
| ingress-port | source-ip |
source-mac | source-port } *
46
interface bridge-aggregation
interface-number
Remarks
N/A
By default, the system selects the global load
sharing criteria according to the packet type.
Remarks
N/A
N/A