Panasonic minas a4 series Instruction Manual page 79

Clearing of Absolute Encoder
Only applicable to the system which uses absolute encoder. You can clear the alarm and multi-turn data of
the absolute encoder.
Operation at SELECTION display
Press four time after pressing
then with , make a display to
Operation at EXECUTION display
Press to call for
EXECUTION DISPLAY of
Then keep pressing
changes to
Clearing of absolute encoder starts
Clearing finishes
After clearing of absolute encoder finishes, return to SELECTION display, referring to structure of each
mode (P.60 and 61).
<Remarks>
Don't disconnect the console from the driver between
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.
, to setup auxiliary function mode,
until the display of Console (LED)
Clearing of absolute encoder
completes
" " increases by
pressing (approx. 5sec)
as the left fig. shows.
Error occurs
(
When non-applicable encoder is
connected
to
[Preparation]
)
.
77