How to Use the Front Panel and Console
EEPROM Writing Mode
EEPROM Writing
Operation at SELECTION display
Starting from the initial LED status,
press
two time after pressing
then brings the display of
EEPROM Writing Mode,
Operation at EXECUTION display
Press
to make
EXECUTION DISPLAY to
Keep pressing
until the display changes to
"
" increases while
keep pressing
(for approx. 5sec) as
the right fig. shows.
Starts writing.
Finishes writing
• When you change the parameters which contents become valid after resetting,
displayed after finishing wiring. Turn off the control power once to reset.
Note 1) When writing error occurs, make writing again. If the writing error repeats many times,
this might be a failure.
Note 2) Don't turn off the power during EEPROM writing. Incorrect data might be written.
If this happens, set up all of parameters again, and re-write after checking the data.
70
,
when you execute writing.
Writing completes
Writing error
will be