ATLANTIC 300 i.e.
•
Connect the following electric connec-
tors in order:
- Pick UP «6».
- Water temperature sensor «7».
•
Place the starter motor earth cable.
•
Tighten the screw «8».
•
Place the starter motor power supply
cable.
•
Tighten the nut «9» and reposition the
rubber protection.
•
Fit the calliper on the rear brake disc.
•
Fit the exhaust system.
•
Fit the helmet compartment.
•
Top-up with coolant.
NOTE
CARRY OUT AN OVERALL CHECK ON ALL THE COMPO-
NENTS THAT HAVE UNDERGONE ANY OPERATION, ES-
PECIALLY THAT:
- the electrical cables are correctly fastened with suitable clamps;
- the electrical connectors are correctly coupled;
- the pipes and sleeves are correctly fitted and secured with suitable clamps;
- the throttle cable must slide freely and must not cause the handlebar to rotate.
CAUTION
AVOID TWISTING AND CRUSHING CABLES.
Engine from vehicle
ENG VE - 95