ATLANTIC 300 i.e.
•
Unscrew and pull out the measuring
cap-dipstick «1».
•
Clean the area in contact with oil with
a clean cloth.
•
Screw the cap-dipstick «1» fully into its
tube.
•
Remove the cap-dipstick «1» again
and read the level the oil reaches on
the dipstick:
MAX = maximum level;
MIN = minimum level.
•
The level is correct when it is close to
the MAX level marked on the measur-
ing dipstick.
CAUTION
DO NOT GO BEYOND THE MAX AND BELOW THE MIN
LEVEL MARKS TO AVOID SEVERE ENGINE DAMAGE.
TOP-UP
•
Pour a small quantity of oil through the tube and wait about one minute so that the oil flows
evenly into the crankcase.
•
Check the oil level and top up, if required.
•
Top up with small quantities of oil, until the recommended level is reached.
•
At the end of the operation, screw and tighten the tap-dipstick «1».
CAUTION
DO NOT RIDE THE MOTORCYCLE WITH INSUFFICIENT LUBRICATION OR WITH CONTAMINA-
TED OR INCORRECT LUBRICANTS AS THIS ACCELERATES THE WEAR AND TEAR OF THE
MOVING PARTS AND CAN CAUSE IRRETRIEVABLE DAMAGE.
Replacement
•
Park the vehicle on firm and level ground.
•
Park the vehicle on its centre stand.
CAUTION
Maintenance
MAIN - 45