ATLANTIC 300 i.e.
Removal
•
Undo and remove the two screws «1».
•
Slide off the brake calliper from the
disc.
Locking torques (N*m)
Screw fixing calliper to muffler plate 25 ± 20% (18.5 ftlb)
•
Remove the seeger ring «2».
•
Slide off the pin «3».
•
Remove the spring «4».
•
Take out the pads «5» sliding them off one at a time.
CAUTION
AFTER REMOVING THE PADS, DO NOT OPERATE THE BRAKE LEVER; OTHERWISE, THE CAL-
LIPER PLUNGER COULD GO OUT OF ITS SEAT RESULTING IN BRAKE FLUID LEAKAGE.
•
Replace the pads «5».
•
Insert the two new brake pads.
•
Insert the spring «4» correctly.
•
Insert the pin «3».
•
Fit the seeger ring «2».
•
Check the brake fluid.
CAUTION
ALWAYS REPLACE BOTH PADS AND MAKE SURE THEY ARE CORRECTLY POSITIONED IN-
SIDE THE CALLIPER.
Braking system
BRAK SYS - 223