APRILIA Atlantic 300 Service Station Manual page 173

ATLANTIC 300 i.e.
7
8
9
10 Electric fan remote control
Checking the resistance at the injector ends: 14.5 ± 5% Ohm
Check the efficiency of 15A fuse No.4 of the injection load.
Check the efficiency of the injection load remote
control: Check the resistance of the energising coil
between pins 86 and 85: 80 ÷ 120 Ohm.
Apply a voltage of 12V to pins 86 and 85; make
sure that there is continuity between pins 30 and
87 of the remote control.
Check the power supply line of the injection load
remote control energising coil: upon switching to
"ON", make sure there is battery voltage for 2 sec-
onds between the green-red cable and the blue-
red cable of the remote control base. If there is
none, check the continuity of the Green-Red cable
between the fuse box under the saddle hinge and
the remote control base, and check the continuity
of the Red-Blue cable between pin 20 of the con-
trol unit and the remote control base.
NOTE
CONTINUITY TESTS MUST BE CARRIED OUT WITH THE
COMPONENTS DISCONNECTED. (BATTERY, REMOTE
CONTROLS, CONTROL UNIT, FUSES, ETC.).
Specification
Fuel pump
HV coil
Fuel injector
Injection
Desc./Quantity
INJEC - 173