Maintenance
•
Stop the engine and let it cool off so
that the oil in the crankcase flows down
and cools as well.
•
Unscrew and pull out the measuring
cap-dipstick «1».
•
Place a collecting container with +
1300 cm³ capacity under the engine oil
filter.
•
Unscrew and remove the cartridge en-
gine oil filter «2».
•
Unscrew and remove the oil drainage
plug «3» and then drain all the engine
oil into the collecting container.
•
Fit a new oil cartridge filter and take
special care to lubricate the filter seal-
ing O-rings with oil.
•
Screw and tighten the engine oil drain-
age plug «3».
•
When refilling, add approx. 1300 cm³ of engine oil through the fill opening.
•
Screw and tighten the measuring cap-dipstick «1».
•
Start the engine and let it run for several minutes. Stop the engine and let it cool down.
•
Check the engine oil level again using the cap-dipstick «1» and top-up, if necessary, without
exceeding the "MAX" level.
NOTE
USE RECOMMENDED OIL ONLY. REFER TO THE RECOMMENDED PRODUCTS TABLE.
Check
NOTE
PARK THE MOTORCYCLE ON SAFE AND LEVEL GROUND.
•
Park the vehicle on its centre stand.
CAUTION
WAIT SOME MINUTES UNTIL THE ENGINE AND THE EXHAUST SYSTEM ARE COLD.
MAIN - 48
ATLANTIC 300 i.e.