Table of Contents
Advertisement
ATLANTIC 300 i.e.
Refit the driven pulley shaft bearing with a modular
punch as shown in the figure.
NOTE
IF A BEARING WITH AN ASYMMETRICAL BALL RETEN-
TION CAGE IS USED, PLACE IT SO THAT THE BALLS ARE
VISIBLE FROM THE HUB INTERNAL SIDE.
Specific tooling
020376Y Adapter handle
020359Y 42 x 47-mm adaptor
020363Y Crankshaft oil seal punch D 20 mm
NOTE
WHEN FITTING THE BEARINGS ON THE ENGINE CRANKCASE, THE CRANKCASE SHOULD, AS
FAR AS POSSIBLE, BE SUPPORTED ON A SURFACE TO ALLOW THE BEARINGS TO BE DRIV-
EN VERTICALLY.
Refit the seeger ring with the opening facing the bearing opposite and fit the new oil guard levelled with
the crankcase on the pulley side.
Refitting the hub bearings
- Assemble the 3 shafts in the engine crankcase
as shown in the figure.
Engine
ENG - 117
Hide quick links:
Advertisement
Table of Contents
