APRILIA Atlantic 300 Service Station Manual page 246

Chassis
•
Unscrew and remove the two screws
«6».
NOTE
THE OPERATIONS INDICATED ABOVE REFER TO RE-
MOVING ONLY ONE FRONT TURN INDICATOR, BUT AP-
PLY TO BOTH INDICATORS.
CAUTION
BEFORE REPLACING A BULB, TURNTHE IGNITION SWITCH TO"OFF". TO REPLACE THE
BULB, WEAR CLEAN GLOVES OR USE A CLEAN DRY CLOTH. DO NOT LEAVE PRINTS ON THE
BULB AS THIS MAY CAUSE IT TO OVERHEAT AND THEN BLOW OUT. IF YOU TOUCH THE
BULB WITHOUT WEARING GLOVES, CLEAN OFF PRINTS WITH ALCOHOL TO AVOID DAMAG-
ING THE BULB.DO NOT FORCE ELECTRICAL CABLES.
NOTE
BEFORE REPLACING A BULB CHECK THE FUSES
TAIL LIGHT BULB REPLACEMENT
•
Place the vehicle on the service stand.
•
Remove the front closing.
CAUTION
PROCEED WITH CAUTION. DO NOT DAMAGE THE TAB AND/OR ITS SLOTS.
•
Working from the rear part of the bulb holder turn and extract the entire bulb holder.
•
Extract the bulb from its fitting.
NOTE
INSERT THE BULB IN THE BULB HOLDER SO THAT THE TWO GUIDING PINS COINCIDE WITH
THEIR GUIDES ON THE BULB HOLDER.
•
Install a bulb of the same type ade-
quately.
CHAS - 246
ATLANTIC 300 i.e.