Skoda Octavia 1996 Service Manual page 113

OCTAVIA
Removing and installing parts of the exhaust system
Notes:
♦ Always replace gaskets and self-locking
nuts.
♦ Use a screwdriver to slacken and tighten the
clamps of the heat shields
Tightening torque: 2 Nm
1 - Tunnel bridge
♦ with hole for aligning exhaust system
⇒ page 26-5
2 - Hanger
♦ installation position ⇒ Fig. 1
3 - 25 Nm
4 - Front exhaust pipe
♦ pay attention to different version
♦ with oxidation catalytic converter
♦ with decoupling element
♦ protect against shocks and blows
♦ avoid a large deflection, max. deflec-
tion 10°
♦ removing and installing ⇒ page 26-2
5 - 40 Nm
♦ replace
♦ insert with hot screw paste G 052 112
A3
Edition 10.02
S00.5105.54.20
Exhaust System
6 - Gasket
♦ replace
7 - Exhaust manifold
♦ removing and installing ⇒ page 26-3
8 - 25 Nm
♦ replace
♦ insert with hot screw paste G 052 112
A3
9 - Washer
10 - Lambda probe, 50 Nm
♦ grease only thread with hot screw
paste G 052 112 A3; the hot screw
paste must not come into contact with
the slot of the probe body
♦ check:
⇒ 1.6 l/74 kW Engine, Simos 2 Fuel injec-
tion and Ignition system; Repair Group 24
♦ plug connection for lambda probe be-
low protective cover ⇒ page 26-2
11 - Double clamp
♦ align exhaust system free of stress
before tightening ⇒ page 26-5
♦ installation position: synchronously for
vehicle floor, bolted connection points
toward left
♦ tighten bolted connections evenly
12 - 40 Nm
13 - Hanger
14 - Front and rear silencer
♦ replace individually when carrying out
repairs ⇒ page 26-4
♦ align exhaust system free of stress
⇒ page 26-5
26
------------ 26-1 ------------