Skoda Octavia 1996 Service Manual page 116

26
¡ ¢ £
------------ ------------
0 1 $ " ! !  1 2
3 # 4  # 1  1 " $ 5 4
Exhaust System
Notes:
♦ Use only 4 mm thick washers.
♦ Replace gasket for exhaust manifold.
♦ Always replace self-locking nuts.
  § ¥  © ¥       ! " # # ! $ % ¤ ¥ ¦ § ¨ ©   
Shield to exhaust manifold
Exhaust manifold to cylinder head
Insert with hot bolt paste G 052 112 A3.
1)
- Align exhaust system free of stress ⇒ page
26-5.
- Install front exhaust pipe ⇒ page 26-3.
♦ Torque wrench 5...50 Nm
(e.g. V.A.G 1331)
♦ Body saw (e.g. V.A.G 1523)
A separation point is provided for replacing the
front or the rear silencer when carrying out
repairs.
K - Use a body saw (e.g. V.A.G 1523) to sepa-
rate the exhaust pipe at the separation point
-arrow 2- at right angles.
- Position clamping sleeve -4- at the side
markings -arrows 1 and 3- when installing.
- Align exhaust system free of stress ⇒ page
26-5.
- Align rear silencer horizontally.
- Tighten bolted connections of clamping
sleeve evenly to 40 Nm.
- Installation position of clamping sleeve:
horizontal in vehicle, bolted connections
pointing forward.
&  ' (  &  )
front or rear
testers and aids
OCTAVIA
25
25
1)
Edition 12.99
S00.5105.52.20