Skoda Octavia 1996 Service Manual page 27

OCTAVIA
Edition 10.02
S00.5105.54.20
Crank Assembly
K Fig. 1 Tightening sequence of bolts at
compact holder
Removing ribbed V-belt
Note:
Mark the direction of running of the ribbed V-
belt before removing it. If an already used belt
is fitted on again to run in the opposite direction,
it may be destroyed. When installing the belt,
ensure it is correctly located in the belt pulleys.
K - Swivel tensioning device in direction of -ar-
row- and secure with drift T10060 in order to
slacken the ribbed V-belt.
Note:
The tensioning device can be locked with a 3
mm external hexagon wrench.
- Take off ribbed V-belt.
Installing ribbed V-belt
Note:
Before installing the ribbed V-belt, ensure that
all the components (alternator, AC compressor,
hydraulic pump) are tightly fitted.
- Fit on ribbed V-belt
K - Slacken tensioning device for ribbed V-belt.
Remove drift T10060 -arrows-.
- Start engine and check running of belt.
Note:
Engines fitted with AC compressor have a dou-
ble ribbed V-belt.
13
------------ 13-3 ------------