Skoda Octavia 1996 Service Manual page 39

OCTAVIA
Edition 10.02
S00.5105.54.20
Crank Assembly
- When bolting on counterholder, place 2
washers between toothed belt sprocket and
counterholder.
- Screw central bolt of toothed belt sprocket
into the crankshaft again.
- Turn out inner part of seal extractor MP 1-
226 two turns (about 3 mm) out of the outer
part and lock with knurled screw.
K - Oil threaded head of seal extractor MP 1-
¢ £ ¤ ¥ ¥ ¦ ¡
¡ §
226, fit on and screw as far as possible into
the seal with firm pressure.
- Slacken knurled screw and turn inner part
against the crankshaft until the seal is pulled
out.
elastomer seal
- Apply a thin film of oil to the sealing lip of the
seal.
K - Fit guide sleeve from MP 1-314 onto the
crankshaft journal.
- Push seal over guide sleeve.
K - Use central bolt -1- and thrust sleeve from
MP 1-315 in seal flush.
13
¨ ©  ¨   ¨
------------ ------------