Removing Cylinder Head - Skoda Octavia 1996 Service Manual

OCTAVIA
Edition 05.01
S00.5105.53.20
Cylinder Head/Valve Gear

Removing cylinder head

Note:
All cable straps which are detached or cut open
when removing the cylinder head, should be fit-
ted on again at the same point when installing.
Special tools, testers and aids required
♦ Drip tray, e.g. V.A.G 1306
♦ Pliers for spring strap clips
♦ Wrench for cylinder head bolts, e.g. 3452
Engine installed
- On vehicles fitted with coded radio set, pay
attention to code, determine if necessary.
- Switch off ignition (if not already off) and dis-
connect earth strap at battery.
- Remove top part of intake manifold ⇒ page
15-4.
- Open cap of coolant expansion reservoir.
K - Remove noise insulation panel in middle as
well as on left -arrows-.
- Unbolt front exhaust pipe from the exhaust
manifold ⇒ page 26-2.
K - Turn drain valve -arrow- at radiator to the left
and pull it back; fit auxiliary hose onto con-
nection, if necessary.
15
------------ 15-7 ------------