Skoda Octavia 1996 Service Manual page 60

15
¡ ¢ £
------------ ------------
Cylinder Head/Valve Gear
Procedure
- Position crankshaft and camshaft to TDC of
cylinder 1 before fitting on the cylinder head
⇒ page 15-8.
- Fit on cylinder head gasket and lock dowel
sleeves. Inscription (part number) should be
legible.
- Insert new cylinder head bolts and tighten
by hand.
K - Tighten cylinder head in two stages in the
tightening sequence shown, as follows:
- 1st stage: 40 Nm
- 2nd stage, torque further with a rigid wrench:
180° (½ turn)
2 x 90° is also permissible
Note:
It is not necessary to re-tighten the cylinder head
bolts after performing repairs.
- Install toothed belt, tension (setting timing)
⇒ page 13-8.
- Install ribbed V-belt ⇒ page 13-4.
- Install cylinder head cover ⇒ page 15-6.
- Install top part of intake manifold
⇒ page 15-6.
- Set throttle cable ⇒ page 20-13.
- Fill system with coolant ⇒ page 19-2.
- Interrogate fault memory, carry out basic sett-
ing:
⇒ 1.6-ltr./74 kW Engine, Simos 2 Fuel Injection
and Ignition System; Repair Group 01; Self-
Diagnosis; Interrogating and erasing fault
memory, basic setting of engine
OCTAVIA
Edition 05.97
S00.5105.51.20