Skoda Octavia 1996 Service Manual page 37

OCTAVIA
Edition 10.02
S00.5105.54.20
¡ ¢ £ ¤ ¥ ¦ § ¡ ¨ ¢
  ¦ ¡ ¨ ¢
Crank Assembly
♦ Do not replace a PTFE seal (new version)
with an elastomer seal (old version).
    ¦    ¡ ¨ ¢
♦ A PTFE seal may be installed in place of an
elastomer seal.
3
K
The crankshaft bearing shells are factory-
marked. The top crankshaft bearing shells are
based on the marking on the cylinder block
(stamped letters)
Notes:
♦ -Arrow- points toward belt pulley
♦ Marking of bearing is visible, without remov-
¡ ¢ £ " #
ing oil pan.
letters on the cylinder block.
R = red
Y = yellow
B = blue
W = white
The bottom crankshaft bearing shells are always
supplied as replacement parts with the colour
coding „yellow“.
em
K
rotor
- Replace each time sensor rotor -2- and bolt
-1- are slackened
Notes:
♦ After being attached a second time, the at-
tachment point in the sensor rotor -2- is suf-
ficiently misshapen, that the bolt head -1-
rests against the crankshaft -3- -arrows- and
the sensor rotor is positioned loosely below
the screws.
♦ Assembly only possible in one position, -holes
are offset-.
©  ¥ ¦ ¡ ¨ ¢
  ¥     ¨   ¥ ¦ 
¦  
 ¥ ¦ ¡ ¨ ¢  ¥   ! ¡ ¨ ¢
crankshaft
$ ¡ ¨ ¢ ¡ ¨   ¥   ¡ ¨ ¢

of b shells
and
13
for or-
the
sensor
------------ 13-13 ------------