15
¡ ¢ £
------------
------------
Cylinder Head/Valve Gear
Replacing camshaft seal
Special tools, testers and aids required
♦ Counterholder MP 1-216
♦ Seal extractor MP 1-215
♦ Seal insertion tool MP 1-214
♦ Torque wrench
♦ Thrust sleeve T10071
♦ Guide sleeve T10071/1
Removing
-
Remove top part of toothed belt guard.
-
Detach camshaft sprocket (use counter-
holder MP 1-216).
K -
Position camshaft sprocket to TDC marking
of cylinder 1 by rotating at crankshaft. Mark-
ing on camshaft sprocket must be aligned
with arrow on toothed belt guard.
-
Slacken tensioning pulley and take off
toothed belt.
-
Remove camshaft sprocket.
-
Take out parallel key at camshaft.
-
Screw in bolt for attaching camshaft sprocket
into the camshaft as far as the stop.
K -
Position inner part of seal extractor MP 1-
215 flush with outer part and lock with knurled
screw.
-
Oil threaded head of seal extractor, position
and screw into the seal as far as possible
using considerable force.
-
Slacken knurled screw and turn inner part
against the camshaft until the seal is pulled
out.
OCTAVIA
Edition 05.01
S00.5105.53.20