Skoda Octavia 1996 Service Manual page 101

OCTAVIA
8 - Vent valve
♦ inspecting ⇒ Fig. 1
9 - Earth connection
10 - 10 Nm
11 - Vent lines
12 - Fuel tank
♦ removing and installing ⇒ page 20-6
13 - Clamping washer
♦ removing: turn to left
♦ installing: tighten to 2 Nm
14 - Heat shield
♦ for fuel tank
15 - 20 Nm + torque a further 1/4 turn (90°)
16 - Clamping nut
♦ installing: tighten to 2 Nm
17 - Cover
♦ for fuel tank
18 - Tensioning strap
♦ pay attention to different lengths
19 - Feed line
♦ black
♦ to fuel rail
♦ to detach, press unlocking button on
connector
20 - Fuel filter
♦ installation position: arrow points in
direction of flow
Edition 05.01
S00.5105.53.20
Fuel Supply System
21 - Retaining clip
♦ for fuel filter
22 - Seal
♦ moisten with fuel for installing
♦ replace if damaged
23 - Fuel delivery unit
♦ removing and installing ⇒ page 20-5
♦ testing fuel pump ⇒ page 20-9
♦ removing and installing fuel gauge
sender ⇒ page 20-6
♦ testing holding pressure:
⇒ 1.6 l/74 kW Engine, Simos 2 Fuel Injection
and Ignition System; Repair Group 24; Test-
ing fuel pressure regulator
24 - Union nut, 80 Nm
♦ use wrench MP 1-227 for removing
and installing
25 - Feed line
♦ black
♦ to fuel filter
♦ is attached to connection marked „V“
at closing flange
♦ to detach from closing flange, press
unlocking button on connector
26 - Return-flow line
♦ blue
♦ from fuel rail
♦ is attached to connection marked „R“
at closing flange
♦ to detach from closing flange, press
unlocking button on connector
K Fig. 1 Inspecting vent valve
Lever in off position: valve closed
Lever pushed in direction of arrow: valve open
20
------------ 20-3 ------------