Skoda Octavia 1996 Service Manual page 36

13
------------ 13-12 ------------
Crank Assembly
18 - Intermediate plate
♦ is attached to sealing flange ⇒ Fig. 1
♦ must be placed on dowel sleeves
♦ do not damage or bend when carry-
ing out removal and installation work
19 - 15 Nm
20 - Rear sealing flange with seal
♦ always replace complete
♦ must be located on dowel sleeves
♦ to remove, take off oil pan ⇒ page 17-3
♦ clean sealing surface before installing
♦ sealing flange is supplied with PTFE
seal as replacement part
♦ install seal dry, crankshaft journal must
be free of grease
♦ install new sealing flange with sleeve
( do not pull sleeve off sealing ring
before installing)
K Fig. 1 Installing intermediate plate
- Attach intermediate plate to the sealing
flange and fit onto dowel sleeves -arrows-.
K Fig. 2 Seal versions
I Elastomer seal
1 sealing lip -1-; with worm spring
II PTFE seal
Several sealing lips -2-; without worm spring
Notes:
♦ Do not moisten PTFE seal with oil before
installing. The shaft must also be free of oil
and grease.
OCTAVIA
Edition 10.02
S00.5105.54.20