Configuration > Igmp Snooping > Host Table; Configuration > Mld Snooping > Mld Snooping Settings - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
Configuration > IGMP Snooping > Host Table
The Host Table page displays the information of Host Table. Including VLAN ID, Group, Port Number and
Host IP.
Figure 4.57 - Configuration > IGMP Snooping > Host Table
Configuration > MLD Snooping > MLD Snooping Settings
The MLD Snooping Settings page allows you to configure the max multicast group for IGMP Snooping.
Figure 4.58 - Configuration > MLD Snooping > MLD Snooping Settings
MLD Snooping: Enable or disable the MLD Snooping.
The VLAN Settings of MLD snooping:
Click the Edit button to enter the Querier Timers Settings page.
Figure 4.59 – Configuration > MLD Snooping > Querier Timer Settings
Host Timeout (130-153025 sec): Specifies the time interval in seconds after which a port is removed from a
Multicast Group. Ports are removed if a Multicast group MLD report was not received from a Multicast port
within the defined Host Timeout period. The possible field range is 130 - 153025 seconds. The default
timeout is 260 seconds.
Router Timeout (60-600 sec): Specifies the time interval in seconds the Multicast router waits to receive a
message before it times out. The possible field range is 60 - 600 seconds. The default timeout is 125
seconds.
Robustness Variable (2-255): The Robustness Variable allows adjustment for the expected packet loss
on a subnet. If a subnet is expected to be lossy, the Robustness Variable may be increased. The
Robustness Variable can not be set zero, and SHOULD NOT be one. Default is 2 seconds.
Last Member Query Interval (1-25 sec): The Last Member Query Interval is the Max Response Time
inserted into Group-Specific Queries sent in response to Leave Group messages, and is also the amount of
time between Group-Specific Query messages. This value may be adjusted to modify the "leave latency" of
the network. A reduced value results in reduced time to detect the loss of the last member of a group. Default
is 1 second.
Query Interval (60-600 sec): The Query Interval is the interval between General Queries sent. By adjusting
the Query Interval, the number of MLD messages can increase or decrease; larger values cause MLD
Queries to be sent less often. Default is 125 seconds.
3 3 9 9