Mitsubishi Q00JCPU User Manual page 672

APPENDICES
Number Name Meaning
Current Current operating
SD1650
operating status status
Network module
Network module
head address,
head address,
which requested
which requested
SD1690 system
system switching
switching on
on host (control)
host (control)
system
system
*2 : Shows the special register (SD
App
Appendix 2 Special Register List
- 77
TableApp.34 Special register
Explanation
Stores the operation information of the other system CPU module in the
following format.
"00FF " I stored when a communication error occurs, or when in debug
H
mode.
b15 to b8 b7 to
0
SD1650
0:No error
1:Continue error
2:Stop error
F:Communication with
other system
disabled ( )
0:RUN
2:STOP
3:PAUSE
F:Communication with
other system
disabled
( )
Note : A communication error is caused by the following:.
• When the power supply is switched off, or when the other system is rest.
• H/W error occurs on either of system A or B.
• WDT error occurs.
• Tracking cable is not connected.
• Tracking cable is disconnected or damaged.
• Stores head address of network module which a system switch request
was initiated, using the following format.
• Turns off automatically by system, after network error is reset by user.
b15 to b11 to
0
SD1690 0/1
• Please refer to SD1590 which stores the corresponding head address of
network module on host system.
) for the host system CPU.
b4 b3 b0 to
: Communication
with other system
disabled, debug
mode
Each bit
b1 b0
0:OFF
0/1 0
1:ON
Module 0: CPU module is
invalid as it is 2-
slot model
Module 1: Module on right
side of CPU
to
module
Module11: Module at
rightmost end of
12-slot base
(Q312B)
Corres-
ponding
Set by
Corresponding CPU
ACPU
(When set)
SD *2
S(Every END)
New
S(Every END)
QnPRH