Procedure For Writing One Program - Mitsubishi Q00JCPU User Manual

11
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE

11.2.3 Procedure for writing one program

This section explains the procedure for writing the parameters and program created by GX
Developer to the High Performance model QCPU, Process CPU or Redundant CPU.
This section explains the procedure for writing a program to the program memory
(
When storing the program into the standard ROM or memory card and executing boot run,
perform the procedure given in this section, and then carry out the procedure given in Sec-
tion 11.2.5.
In the following procedure,
indicates that on the High Performance model QCPU, Process CPU or Redundant CPU
side.
Section 5.2.2).
indicates the operation on the GX Developer side, and
Start
Start GX Developer.
Set the project.
Do you
NO
change the number
of device points
used?
YES
Change the number of device points in
device setting of PLC parameter.
Create a program to be executed in the
CPU module.
1)
11.2 High Performance Model QCPU, Process CPU, Redundant CPU
GX Developer Operating Manual
Section 9.2
Ladder (write) screen
............
11.2.3 Procedure for writing one program
9
10
11
11
- 10