Settings For Creation And Execution Of Multiple Sequence Programs - Mitsubishi Q00JCPU User Manual

3
SEQUENCE PROGRAM CONFIGURATION AND
EXECUTION CONDITIONS
3.3 Settings for Creation and Execution of Multiple Sequence
Basic
Programs
Note3.15
When multiple sequence programs are created, the execution type can be specified for
each program, e.g. a program started only once at startup or a program executed at fixed
intervals.Note15
(1) Applications for multiple sequence programs creation
(2) Settings required for execution of multiple programs
Note15
Basic
Since the Basic model QCPU cannot execute multiple programs, the settings for creation and
execution of multiple sequence programs are not available.
Note3.15
A program can be divided into multiple programs on the basis of each control unit and
stored into the CPU module. (They can also be stored as a single program.)
This enables programming to be shared by each designer for each processing unit.
Control as one program
Control data A
Control data B
Control data n
Diagram 3.19 Control divided into multiple programs
* 1 : Refer to the following sections for the program storage location.
•Basic model QCPU
•High Performance model QCPU, Process CPU or Redundant CPU :
When multiple programs are to be executed by the CPU module, the file names
(program names) and execution conditions of the programs must be preset.
Make the program settings in the PLC parameter dialog box of GX Developer.
( Section 3.3.6)

3.3 Settings for Creation and Execution of Multiple Sequence Programs

Program A
Control data A
Program B
Control divided into
multiple programs
Control data B
Program n
Control data n
Divided and
registered by
1
control data
: Section 5.1.1
Section 5.2.1
3
- 24
1
2
3
4
5
6
7
8