Mitsubishi Q00JCPU User Manual page 427

8
PARAMETERS
(11)Multiple CPU setting
Item Parameter No.
Number of PLC 0E00
Operation mode 0E01
All CPUs
can read all
I/O sharing
inputs
when using
0E04
Multiple
CPUs
All CPUs
can read all
outputs
E002
Refresh setting
E003
Make the settings to configure a multiple CPU system.
Table8.11 Multiple CPU setting list
Description
Set the number of CPU modules
used by the multiple CPU
H
system.
Set the multiple CPU system
operation to be performed when
the CPU module No. 2 or No. 3
results in a stop error.
H
When the CPU No. 1 results in a
stop error, the multiple CPU
system stops. (Fixed)
Set whether the input status of
the input module or intelligent
function module controlled by
the other CPU will be imported
or not.
H
Set whether the output status of
the output module controlled by
the other CPU will be imported
or not.
Set the device and its number of
points to/from which data will be
H
written/read by auto refresh
H
between the CPU modules of the
multiple CPU system.
Diagram 8.11 Multiple CPU setting
Setting range
1 to 3 modules
Stop/Do not stop all CPUs at
error of CPU No. n
Do not import non-group input
status/Import non-group input
status
Do not import non-group output
status/Import non-group output
status
[Transmission range of each
CPU module]
0 to 320 points (2 point units)/
module
Max. 4416/system
[CPU module side device]
B,M,Y,D,R,ZR
The device points set in the
transmission range are
occupied, starting from the
specified device number.
• 16 points of B, M or Y are
occupied in the transmission
range of one point.
• 1 point of D, W, R or ZR is
occupied in the transmission
range of one point.
8.1 PLC Parameters
8.1.1 Basic model QCPU
Default value Reference
1 module
Stop all CPUs at
error of CPU No. n
Do not import non-
group input status
Refer to "8.2.2
Parameters
Do not import non-
necessary for using
group output status
multiple CPU system"
in QCPU User's
Manual (Multiple CPU
System).
No setting
8
1
2
3
4
5
6
7
8
- 13