Port 100Ge Dwdm Line Card - Cisco NCS 4000 Series Hardware Installation

2-Port 100GE DWDM Line Card

Table 33: 2-Port 100GE OTN LC Descriptions
LED
Status
Attention
Port
16 The Attention LED can be lit only by using the hw-module attention-led location CLI command, which is useful for identifying and verifying which card needs
attention.
Physical Characteristics
• Height—11.05 in. (280.6 mm)
• Width—1.55 in. (39.4 mm)
• Depth—14.25 in. (362 mm)
• Weight—5.95 lb (2.7 kg)
2-Port 100GE DWDM Line Card
The 2-port 100GE DWDM LC (NCS4K-2H-W) can transport two 100GE or OTU4 signals over a 50-GHz
spaced, 50-GHz stabilized, ITU-compliant wavelength with more than 4500 km of unregenerated reach. The
card also features two CPAK pluggable optics that can map each client signal to a single DWDM line interface.
Hardware Installation Guide for Cisco NCS 4000 Series
220
State
Green
Yellow
Off
16
Blue
Off
Green
Yellow
Off
Installing Route Processor Cards, Fabric Cards, and Line Cards
Description
The LC is properly seated and
operating correctly.
The LC has one or more errors
detected.
No power is applied to the LC.
The card needs attention.
The card does not need attention.
The link is up (including internal
loopback).
The link is down or a hardware
failure has occurred.
The slice is unprovisioned by
software, the optics module is
missing, or the slice has been
powered down.