Replacing The Craft Panel - Cisco NCS 4000 Series Hardware Installation

Replacing the Craft Panel

Step 2 Open the craft panel and rotate it .
Figure 138: Opening the Craft Panel
1
2
3
Step 3 Disconnect the craft cable from the ECU faceplate.
Step 4
Loosen the two connector screws and remove the connector.
Step 5 Remove the craft panel. Lift up the panel to disengage the hinge pins on the left side from the chassis.
Replacing the Craft Panel
To replace the craft panel:
Procedure
Step 1 Engage the hinge pins on the left side of the chassis.
Step 2 Connect the craft cable to the ECU faceplate.
Step 3 Tighten the two connector screws to a torque value of 4.4lbs.
Step 4
Close the craft panel and rotate it.
Step 5 Tighten the two wing-head screws on the right side.
Hardware Installation Guide for Cisco NCS 4000 Series
264
Craft cable
Connector
Three cable ties to hold the LCD cables
Removing and Replacing Chassis Components